This error is displayed when a system error (system crash) is detected.
[In cases where the error occurs during normal communication]
<Causes>
- System program crash due to noise
- Hardware problem
- Faulty system program
<Solutions>
TS/V8 series
Check if the situation is restored by restarting or by turning the power off and on.
If not restored, record the following three numbers that are displayed on the [System Error] screen and contact your HAKKO representative.
- Screen No.
- Error Code
- [More Info] → All error codes
V7 series
Check if the situation is restored by turning the power off and on.
If not restored, record the following two numbers that are displayed on the [System Error] screen and contact your HAKKO representative.
- System Error No.
- Entire list of error codes
[When the error occurs immediately after screen data transfer and disables running]
<Cause>
Screen data may be corrupted.
<Solution>
Delete the data portion added or modified to the screen data, and transfer data again. If restored, the added or modified data portion contains the cause of the error.
Reconfigure the data portion newly.
If the error is not cleared, record the following numbers that are displayed on the [System Error] screen and contact your HAKKO representative.
TS/V8 series
- Screen No.
- Error Code
- [More Info] → All error codes
V7 series
- System Error No.
- Entire list of error codes
Click here for product inquiries.
Was this page helpful?
Please cooperate with the questionnaire to make it better.