The adjustment procedure differs according to the V/TS2060 series display specification.
[TFT color display]
Adjust the brightness (luminance) of the screen. *1
There are two methods for adjustment.
| Applicable models | TS2060(i), TS1100Si, TS1070S(i), V815iX, V812(i)S, V810(i)S, V810(i)T, V810(i)C, V808(i)S, V808(i)C, V808(i)CH *2, V806(i)T, V806(i)C *2, V806(i)M *2 V715X, V712(i)S, V710(i)T, V710(i)S, V710C, V708S, V708(i)S, V706T |
|
| Adjustment *3 | (1) | Use the function switch on MONITOUCH to adjust the brightness in three levels. Press the [SYSTEM] switch and while the main menu is being displayed, press the following function switch: F2: Bright F3: Medium F4: Dark |
| (2) | Use the BRIGHT macro to adjust the brightness in 128 levels. *4 BRIGHT F0 F0 0: maximum brightness to 127: minimum brightness |
|
*1 The present brightness is output to $s956.
*2 Applicable to the following versions:
| Model | Version | Remark |
| V808(i)CH | Hardware version "b" and later System program version 1.670 and later |
|
| V806C(i), V806(i)M |
Hardware version "r" and later System program version 1.890 and later |
LED backlight |
*3 If the power is turned off and on after brightness adjustment, the value set last will apply.
*4
- When a macro has been executed, communication will stop for about several 100 ms to save the setting value to FROM.
Do not execute the macro frequently. - If MONITOUCH is turned off and on with a low brightness value set, the backlight may not turn ON.
[STN color or monochrome display]
Adjust the contrast (light and dark) of the screen. There are two methods for adjustment.
| Applicable models | V806(i)C *1, V806(i)M *1, V708C, V706C *2, V706M *2, V606e *2 | |
| Adjustment *3 | (1) | Use the function switch on MONITOUCH to adjust the contrast. Press the [SYSTEM] switch and while the main menu is being displayed, press the following function switch: Hold down the switch for more than one second to adjust it quickly. F2: Light F3: Medium F4: Dark |
| (2) | Use the CONTRAST macro to adjust the brightness in 100 levels. SYS (CONTRAST) F1 F1+0 0: UP, 1: DOWN, 2: CENTER F1+1 UP/DOWN width 0 to 100 ([F1+0]=2: Invalid) |
|
- *1 In the case of V806C and V806M, this is applicable if the hardware version is "a" to
"q". With "r" and later, the TFT display (with LED backlight) is used so this is not
applicable. - *2 In the case of V706C, V706M and V606e, the setting value is saved to FROM.
While saving, communication will stop for about several 100 ms. Do not execute
the macro frequently. - *3 If the power is turned off and on after contrast adjustment, the value set last will
apply.
Was this page helpful?
Please cooperate with the questionnaire to make it better.
