<Causes>

1. When the PLC model setting is changed, it is replaced with device "??".
2. PLC2 - 8 are set as "not used" (delete).
3. Variable name cooperation is not accomplished with a PLC project file of Fuji Electric's MICREX-SX.

<Solutions>

1. When changing the PLC model, display the [Device Conversion] dialog and change "??" to an existing device memory address under [After Change Start Device].
   
   Example: Change the PLC from Mitsubishi's QnU series CPU → Fuji Electric's MICREX-SX series CPU.
   (1)After the PLC model is changed, the "Execute device conversion?"
   　message dialog will be displayed. Click [Yes].
   
   
   (2)Click the "??" device memory after conversion that corresponds to
   　the "M"device memory before conversion.
   
   
   (3) Set WM0 in the [Device Input] dialog, and click [OK].
   
   "M" device memory is changed so that it will start from WM0.
   
   
   
2. Correct or delete all illegal device memory addresses.
   Illegal device memory addresses can be found by running an error check.
   
   Example: [Tool] → [Error Check]
   
   
   Click the [Jump to Error Item] icon to jump to the error occurring position.
   Delete or modify the illegal device memory address.
   
   
   
3. Link up with the PLC project file.
   List of PLC models which require linkup (IEC mode only *)

• MICREX-SX (T-link)
• MICREX-SX (OPCN-1)
• MICREX-SX (SX bus)
• MICREX-SX SPH/SPB/SPM/SPE/SPF series
• MICREX-SX SPH/SPB/SPM/SPE/SPF CPU
• MICREX-SX (Ethernet)
  * The current mode setting can be viewed by selecting [MICREX-SX] → [Select Device].

(1) Select [MICREX-SX] → [Project] → [Option], and check [? Cooperating work].


(2) Select the PLC project file (extension ".mwt").


(3) Check that the correct PLC project file is displayed for [Path], and click [OK].

*Note the following points for the project name and pathname. If not, the file will not be linked correctly.

• The following characters must not be used for the pathname.
  :, ., =, ;, <, >, [, ], /, ?, |, *, "
• The following characters must not be used for the project name.
  ¥, :, ., =, ;, <, >, [, ], /, ?, |, *, "
• The project name must not exceed 24 characters.
  (24 one-byte characters/12 two-byte characters, one-byte and two-byte characters can be used at the same time)
• The project pathname (from the drive name to the project name) must not exceed 171 characters.