Follow the steps below.

* If you are using the V-SFT-6, see here.

[To call a numeric keypad when an entry target is pressed]
* In the case of models earlier than the V7 series, click here.

Operation example
Pressing on a numerical data display part brings up a keypad equipped with entry keys.

When "521" is entered and the [Enter] key is pressed, it will be written into the memory of entry target. The numeric keypad will disappear.

1. Select [Parts] → [Data Display] → [Num. Display], and place numerical data display parts.
2. Display the [Num. Display] dialog, select [Main] and configure as below.
   - Write target memory
   - Function: Entry Target
   - Check [With Entry Key].
   
   
   
3. Press [Register] to register a numeric keypad.
4. Check [Display Position] and specify the coordinates to determine the keypad display position.
   When the setup has been completed, a multi-overlap icon is displayed in addition to the numerical data display part.
   

[To place entry targets and a numeric keypad on the same screen]

Operation example
When "521" is entered from the numeric keypad and the [Enter] key is pressed, it will be written into the memory of entry target.

1. Select [Parts] → [Data Display] → [Num. Display], and place numerical data display parts.
2. Display the [Num. Display] dialog, select [Main], and set the write target memory and [Function: Entry Target].
   
   
   
3. Select [Parts] → [Entry], and place a numeric keypad.