Screen program transfer is possible using a commercially-available USB or Ethernet cable.
The "V-CP" or "UG00C-T1" serial transfer cable manufactured by Hakko Electronics can also be used.

The following table lists each series and the corresponding available transfer methods.

*1 If the computer is not equipped with a serial port, use a commercially-available
     USB-to-serial converter.
     Connect "V-CP" or "UG00C-T1" to the MJ1 port on MONITOUCH.
*2 A straight cable can also be used with or without a hub.
*3 Type with built-in LAN port.
*4 When the "CU(N)-03-x","UG03I-E" communication unit is installed.
*5 When the "CU-03-x","UG03I-E" communication unit or "DU-01","UG230A-DCL" option
     unit is installed.
*6 When the "CU-03-x","UG03I-E" communication unit is installed.
*7 It is possible to make your own cable for serial transfer with the V4/GD-80/GD-81S
    /UG400/UG210/UG200 by referring to the wiring diagram. 

　　

*8 Serial transfer with the GD-80S cannot be performed using the "V-CP" or "UG00C-T1"
     cable.
     Make your own cable by referring to the wiring diagram.