Follow the procedure below.

* For V8-compatible screen programs, use [Read Area].

1. Click [System Setting] -> [Unit Setting] -> [Buzzer] on the V-SFT editor.
   
   
2. Check [Control Device] and set a PLC device memory address.
   If the [Control Device] menu is absent, refer to "For V8-compatible screen programs" at the bottom of this page.
   
   
   
3. It is also possible to sound a one-shot buzzer or an error buzzer according to commands from the PLC.
   
   Single-shot buzzer (Standard):  100 msec long
   Error buzzer (Short):    10 msec long
   Continuous buzzer:  Continuous
   
   
   * Check [Use Continuous Buzzer Sound] at [System Setting] > [Unit Setting] >
      [General Setting].
      

For V8-compatible screen programs

[Control Device] is not used for screen program converted from V8 series or earlier models. In this case, sound a buzzer using [Read Area].

For more information, click here.