"Battery voltage drop", "Brownout of Battery", "Battery changeover required", "Battery not set"
This error is displayed on the Main Menu screen when a battery problem has occurred to the V/TS series.
In the case of "Battery voltage drop", "Brownout of Battery", "Battery changeover required"
The battery voltage has dropped.
Replace the battery with a new one.
- V8/V7/V606e series
Battery type: V7-BT
- TS2060 series
Battery type: TS-BT(CR2032W/CR2032X)
- TS1000S series
Battery type: CR2032
|How to check the battery condition in the RUN mode The battery condition is output to the internal device memory $s167 of the V/TS2060/TS1000S .
A battery can last for about five years (*1) from the date of purchase. Even if the battery voltage drops (bit 4: ON) before the five years (*1) elapse, replace the battery immediately. (*2)
(With the TS2060/TS1000S/V606e, "1: Battery voltage drop or no battery", "2" not provided)
*1 TS1000S:About three years
*2 When checking the battery condition on the PLC side, use the event timer macro to transfer the information to the PLC memory. For more information, click here.
The battery is not connected.
- Open the battery holder cover at the backside of the MONITOUCH, and connect the battery cable.
(At the time of delivery from the factory: Not connected)
- Replace the battery with a new one.
Battery type: V7-BT (V8/V7/V606e series)
* For the procedure of checking the battery condition in the RUN mode, see above.
Was this page helpful?
Please cooperate with the questionnaire to make it better.