1. Home >
  2. Support >
  3. Download >
  4. Improvement information

Improvement information

The improvement information on X1 is published.

Improvement information Improvement information list


Date of Release 2024/4/25

◆HMI Program
No. Item Description X1 Version
2440L01 Data sampling Fixed the defect: When switching to a screen where data sampling (V8 compatible) is located, operation becomes slow if there is a lot of logging information stored in the secondary storage location (a storage device). 1.700
2440L02 Logging server Fixed the defect: When the reset bit of logging is turned on and off at short intervals, the V10 unit may restart. 1.700
2440L03 Graphic library Fixed the defect: When replacing from V8, the graphic library appears to display differently. 1.700
2440L04 SRAM Fixed the defect: Increasing the number of monitoring alarms does not cause SRAM format errors even though SRAM is set for alarm server storage. 1.700
2440L05 Device memory map Fixed the defect: Device memory map does not work correctly when using a PLC that does not support multipoint commands. 1.700
2440L06 PLC_CTL macro command Fixed the defect: When PLC_CTL macro command is used, the command does not work correctly in the PLC that uses the upper byte of the station number (F1). 1.700
2440L07 macro Fixed the defect: When converting 1/1/1970 00:00:00 into Greenwich time by the macro command [CLND_TO_GRE], Greenwich time may not be converted correctly. 1.700

◆Communication Driver
No. Item Description X1 Version
2440M01 OMRON NJ Series (EthernetIP) Fixed the defect: When calendar data is read from PLC, it may not be read out correctly. 1.470
2440M02 Panasonic LP-RF series Fixed the defect: When using PLC_CTL macro command and sending STC or LSC commands, the X1 unit may restart.
Panasonic LP-RF series 1.420
LP-RF series(Ethernet) 1.420
<-
2440M03 OMRON SYSMAC CP1/CJ1/CJ2 Fixed the defect: When connecting OMRON's PLC, NX1P2 with the Connection Device : OMRON SYSMAC CP1/CJ1/CJ2 selected, a NAK error occurs and communication cannot be established. 1.560
2440M04 Sanmei Electronics
OMRON
Yokogawa Electric
Fixed the defect: When PLC_CTL macro command is used, the command does not work correctly in the PLC that uses the upper byte of the station number (F1).
Cuty Axis 1.420
E5xx 1.570
FA-M3/FA-M3R (Ethernet) 1.490
FA-M3/FA-M3R 1.570
FA-M3/FA-M3R (Ethernet ASCII) 1.440
<-
For details on the update procedure,
please refer to the instructions included in the downloaded update module.